11 41 Oil pump with strainer and motor
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - OIL PUMP WITH STRAINER AND MOTOR
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Intake pipe to bedplate | N54/N54T | M6x30 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 100 ° | |||
| 2AZ Oil pump to bedplate | N54/N54T | M8x123 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | |||
| Angle of rotation | 180 ° | |||
| N54/N54T | M8x31 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
||
| Jointing torque | 10 Nm | |||
| Angle of rotation | 90 ° | |||
| 3AZ Chain module to crankcase and oil pump | N54/N54T | M6x16 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 45 ° | |||
| 4AZ Sprocket to oil pump | N54/N54T | M8 | Jointing torque | 20 Nm |
| Angle of rotation | 45 ° |