11 11 Engine Block, Cylinder Crankcase N54
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE BLOCK AND CYLINDER CRANKCASE SPECIFICATION
| Bore 0 stage 0(1) | mm | 84.000+0.02 | ||
| Bore 0 stage 00 (1) | mm | |||
| Bore 0 stage 1 (1) | mm | 84.250+002 | ||
| Permitted out-of-round of cylinder bore (1) | mm | 0.01 | ||
| Permitted conicity of cylinder bore (1) | mm | 0.01 | ||
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.15 | ||
|
||||