11 22 513 Replacing roller bearing for dual-mass flywheel

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

TRANSMISSION removed.
Remove CLUTCH RELEASE BEARING

Pressing out roller bearing:

Install special tool 23 4 031 in front of drive shaft spline teeth.

Screw in grease spindle 23 4 033 completely.

Brass tip must immerse fully into roller bearing.

Press in grease with grease gun 23 4 040 until roller bearing is disengaged from drive shaft.

When tensioning spring is compressed to full extent, release grease spindle and twist out slightly until spring is relieved.

Repeat grease press-in procedure until roller bearing has released completely.

Fig 1: Removing Dual Mass Flywheel Roller Bearing Using Special Tools

Remove special tool 23 4 031 .

Remove pressed-in grease (1) from drive shaft completely.

Then reinstall special tool.

Fig 2: Removing Drive Shaft Pressed-In Grease Using Special Tool (23 4 031)

Pressing in roller bearing:

Slide in pressure spindle 23 4 035 .

Attach thrust piece 23 4 036 to pressure spindle.

Push roller bearing (1) onto thrust piece.

Fig 3: Pushing Roller Bearing Onto Thrust Piece Using Special Tools (23 4 035) And (23 4 036)

Screw in pressure spindle (1) until roller bearing is fully pressed in.

Fig 4: Tightening Pressure Spindle