51 24 100 Removing and installing/replacing rear lid lock (upper section)

Necessary preliminary tasks: 

• Remove PANEL FOR REAR LID 

Release screws (1).

Tightening torque 51 24 12AZ .

Release screw (2).

Tightening torque 51 24 13AZ .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unfasten screws (2).

Remove rear lid lock upper section (3).

Fig 2: Identifying Rear Lid Lock Upper Section With Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

US version only: 

Disengage Bowden cable (1) for emergency release mechanism.

Remove rear lid lock (2).

Fig 3: Identifying Rear Lid Lock And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Perform function check with rear lid open.