LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> Z4 28i, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Body Equipment - Repair -- Z4_E89) >> Safety And General Information >> 51 00... Notes on installing rubber window seals

51 00... Notes on installing rubber window seals

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Work safety when handling lubricant G14 
    • Wear safety goggles, protective gloves and if necessary an apron.
    • Do not eat, drink or smoke in the area of processing/application
    • Ensure rooms are well ventilated.
    • Keep away from heat and ignition sources
    • In event of skin contact: Wash areas of skin affected with soap and water immediately, change work clothing which has been fouled with lubricant immediately (keep spare work clothing in reserve)
    • In event of eye contact: Rinse eyes immediately with plenty of water and seek medical advice
  2. General notes 
    • Use only the BMW-approved lubricant for fitting
    • Application only at room and object temperatures between 18 and 25°C
    • Lubricant dries at different rates depending on the quantity, temperature and ventilation and becomes sticky
    • Lubricant can only be used for fitting and not for fault elimination (e.g. grating)
    • Newly painted parts may only be brought into contact with the lubricant after cooling
    • Optimal bonding to the surface is achieved after approx. 48 h. The rubber window seal must not be exposed to mechanical strain beforehand. (car wash, strength test, etc.).
    IMPORTANT: To avoid groaning noises, do not use soapy water (low-surface-tension water with washing-up liquid) or lubricant containing silicone.
  3. Auxiliary materials and tools 
    • Spirit, cleaning cloth, plastic squeegee, needle
    • LUBRICANT G14 
  4. Preparations 
    • Heat and remove anti-friction agent residues with a hot air blower or clean new part thoroughly
    • Immediately prior to fitting, clean the work area with spirit in order to remove silicone and grease residues
    NOTE: Air drying time approx. 1 min:
  5. Assembly 
scientia non olet · About LEMON Manuals