51 23... Adjusting/replacing bump stops (3 of 3)

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Prerequisite: Lid must be correctly adjusted.

Following parts must not be damaged:

(1) Bump stop
(2) Catches

Remove adjusting buffer by pressing latch mechanisms back.

Fig 1: Identifying Bump Stop And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Screw adjusting buffer (1) until the pin (2) can be pulled out.

Slowly pull the pin (2) out approx. 15 mm.

Slowly close engine compartment lid.

The pin (2) is thus pushed into the adjusting buffer (1).

Fig 2: Identifying Buffer And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Raise engine compartment lid.

Unscrew the adjusting buffer (1) until it is flush with the upper edge of the pin (2).

Fig 3: Identifying Buffer And Pin

Courtesy of BMW OF NORTH AMERICA, INC.