51 11 770 Removing and installing/replacing left or right deformation element for front bumper

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE TERMINAL
Remove CARRIER for bumper trim at front
Remove HEADLIGHT

Release screws (1).

Tightening torque 51 11 2AZ .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove expander rivets (1).

Remove and replace expander rivets (2).

Fig 2: Identifying Expander Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque 51 11 3AZ .

Drill out rivets (2) and do not replace any more.

Remove deformation element (3) towards front.

IMPORTANT: After assembly: Adjust headlight.

Fig 3: Identifying Deformation Element With Nut And Rivets

Courtesy of BMW OF NORTH AMERICA, INC.