LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> Z4 28i, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1331 (Wheels And Tires - Repair -- Z4_E89) >> Wheels >> 36 00... Checking tire inflation pressure

36 00... Checking tire inflation pressure

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Through natural air diffusion, a tire loses approx. 0.05 bar per month, which is about 0.03 bar inflation pressure after 6 months.

Driving with low pressure negatively impacts fuel consumption and tire wear, particularly the tendency of run-flat tires to wear unevenly and experience increased abrasion.

In addition, extremely low inflation pressure can adversely affect driving stability or cause tire damage and thus accidents.

Checking inflation pressure (at least twice a month and prior to long trips) as well as adjusting it to the load status of the vehicle is necessary.

Checking tire inflation pressure: 

The pressure information for the approved tire sizes are located on the driver's door post.

If the tire's speed rating letter is not listed, the inflation pressure for the particular size, such as 255/45, applies R17.

When towing a trailer, the higher load inflation pressure listed in the pressure information applies.

Fig 1: Identifying Tire Inflation Pressure Label On Driver Door Post
G11151437Courtesy of BMW OF NORTH AMERICA, INC.

The pressure information applies to tire sizes approved and makes recommended by BMW.

For vehicles with a Run Flat Indicator, the indicator must be initialized after completing repair work.