LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> Z4 28i, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Brakes - Repair -- Z4_E89) >> Rear Brakes >> 34 21 745 Removing and installing or replacing rear left or right brake caliper (TRW)

34 21 745 Removing and installing or replacing rear left or right brake caliper (TRW)

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

Press brake pedal down to floor and secure with pedal support.

NOTE: The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
Fig 1: Locating Pedal Support
G04754178Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Grip brake hose at square head (2) so that connecting piece can not rotate in retaining bracket.

Disconnect brake hose from brake line (1).

Installation note: 

Tightening torque 34 32 1AZ .

Pull off retaining clip (3) so that brake hose can be turned.

Fig 2: Identifying Brake Line With Square Head And Retaining Clip
G06908333Courtesy of BMW OF NORTH AMERICA, INC.

Pull off retaining clip (1) so that brake hose can be turned.

Detach brake hose from brake caliper (2).

Installation note: 

Tightening torque 34 32 3AZ .

Fig 3: Identifying Retaining Clip And Brake Caliper
G06908334Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
NOTE: First tighten brake hose on brake caliper.
Insert brake hose in bracket and screw onto brake pipe.

Disconnect plug connection on parking brake actuator.

IMPORTANT: Switch off ignition at least 30 secs. before disconnecting the plug connection.

Unscrew guide bolts (1).

If necessary, grip at hexagon head (2).

Remove brake caliper (3).

Installation note: 

Replace guide bolts.

Tightening torque 34 21 4AZ .

The PARKING BRAKE ACTUATOR  must be modified if the brake caliper is replaced.

After installation, observe the following: switch on ignition and, using EMF operating element, open parking brake once, close once and open again.

IMPORTANT: After completing work: BLEED BRAKING SYSTEM 
Fig 4: Identifying Brake Caliper And Guide Bolts With Hexagon Head
G06908324Courtesy of BMW OF NORTH AMERICA, INC.