62 30 010 Removing and installing/renewing head-up display
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
IMPORTANT:
Comply with notes and notes on HANDLING OPTICAL FIBRES
.
Risk of damage!
Do not scratch lens of head-up display.
Risk of damage!
Do not scratch lens of head-up display.
Necessary preliminary work:
- Remove INSTRUMENT PANEL TRIM
Release screw (1) on carrier housing (2) at bottom.
Tightening torque 62 30 1AZ .
Remove sound insulation (1) from head-up display (4).
Disconnect plug connections (2).
Release screws (3).
Tightening torque 62 30 1AZ .
Carefully feed out head-up display (4) in upward direction.
Installation note:
Clean lens of head-up display.
Adjust HEAD-UP DISPLAY .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .