41 51... Removing And Installing Door

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Attention.

Do not damage adjoining body components.

The graphics are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Front door:

Tightening torque 41 51 4AZ .

NOTE: Secure door against closing.

Release screw (1) on door stop.

Front door:

Tightening torque 51 21 3AZ .

Fig 1: Locating Door Stop Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Open door up to limit position.

Release screws between both hinge elements at top and bottom.

Front door:

Tightening torque 41 51 1AZ .

Fig 2: Identifying Hinge Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Pull the plug connection from the door post, unlock and disconnect it by pulling out the retaining clip.

Fig 3: Unhinging Door (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Unhinge door by moving upwards and placing it on a suitable surface.

Fig 4: Unhinging Door (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, adjust DOOR .