41 00... Stamping Vehicle Identification Number (Needle Stamping Unit)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Read and comply with GENERAL INFORMATION .

The needle stamping system 360 - VRM - BMW is required to stamp the vehicle identification number.

Order number: 81 43 2 155 736

Fig 1: Identifying Needle Stamping System 360 - VRM BMW

Courtesy of BMW OF NORTH AMERICA, INC.

The needle stamping system 360 tool set comprises:

(1) Display
(2) Mains adapter
(3) Needle stamping unit
(4) Connecting cable
(5) Power cable
(6) Compressed-air hose

NOTE: A compressed-air connection is also required.

Operating pressure approx. 6 bar
Use only dry, oil-free air

Procedure for additional vehicle identification number

Cross through original vehicle identification number.

Fig 2: Identifying Vehicle Identification Number
Courtesy of BMW OF NORTH AMERICA, INC.

Remove ENGINE COMPARTMENT LID SEAL LOCATOR

(1) = Original vehicle identification number (line 1).

Mark position lines (2) in accordance with specified dimensions/measurements.

Dimension "a" = 12 mm

Dimension "b" = 10 mm

Display input:

Select Layout 5 with arrow button.
Enter vehicle identification number with F10.
Press "ENTER" button.

NOTE: With Layout 5 the vehicle identification number (line 1) is crossed through.

Fig 3: Entering Vehicle Identification Number For Stamping

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Perform stamping operation with position lines in advance on a test sheet.

Move suction feet of needle stamping unit to positions (1) and (2) shown.

NOTE: The contact surface for the suction cups of the needle imprint device must be dry and free of dust and grease.
Make sure the unit is resting securely in position. If necessary, adjust the height and position of the suction feet.

Fig 4: Positioning Suction Feet Of Needle Stamping Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Press pushbutton (1) for vacuum pressure.

Then start stamping operation with pushbutton (2).

IMPORTANT: After completing the stamping operation, do not alter the position of the unit.
Do not switch off vacuum pressure.

Fig 5: Identifying Pushbuttons

Courtesy of BMW OF NORTH AMERICA, INC.

Stamping second vehicle identification number

Display input:

Select Layout 2 with arrow button.
Press "ENTER" button.

NOTE: With Layout 2 the already entered vehicle identification number is stamped in line 2.

Fig 6: Entering Vehicle Identification Number For Stamping

Courtesy of BMW OF NORTH AMERICA, INC.

Start stamping operation with pushbutton (2).

After the stamping operation, if necessary adapt ENGINE COMPARTMENT LID SEAL LOCATOR of second vehicle identification number.

Fig 7: Identifying Pushbuttons

Courtesy of BMW OF NORTH AMERICA, INC.

Following layout functions are available:

Layout selection	Vehicle identification number
Layout 1	In line 1
Layout 2	In line 2
Layout 3	Turned through 180° in line 1
Layout 4	Turned through 180° in line 2
Layout 5	Cross through in line 1
Layout 6	Cross through in line 2