66 54 511 Replacing night vision camera

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: New component contains a CD with deblocking code.
Enable code CD is requested during coding/programming by the SSS.
Coding/programming without the enable code CD is not possible.

Necessary preliminary work:

Remove SPRAY NOZZLE FOR NIGHT VISION CAMERA

Release screws (2) on holder for camera (1).

Unclip catches (3) on camera holder (1).

Remove camera including holder (1).

Fig 1: Identifying Latch Mechanisms, Camera Holder And Screws

G06886562

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1) at adjusting screw (2) and press upwards in direction of arrow.

At same time twist out adjusting screw (2) and pull out complete pin with spring.

Fig 2: Pulling Out Complete Pin With Spring

G06886569

Courtesy of BMW OF NORTH AMERICA, INC.

Holder (2) and fixture (3) must also be replaced when replacing camera (1).

Fig 3: Identifying Camera, Holder And Fixture

G06886570

Courtesy of BMW OF NORTH AMERICA, INC.

Assembly of individual parts:

Place mount (2) on camera.

Tighten screws (1).

Tightening torque 66 54 1AZ .

Fig 4: Identifying Mount And Screws

G06886571

Courtesy of BMW OF NORTH AMERICA, INC.

Insert camera (2) with mount in holder.

Retaining lugs (1) on the mount must engage correctly in the guides on the holder (3).

Fig 5: Inserting Camera With Mount Into Holder

G06886572

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Adjust NIGHT VISION CAMERA

Replacement:

Carry out VEHICLE PROGRAMMING AND ENCODING .