66 51 030 Removing and installing/replacing camera for Lane Departure Warning

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Latch mechanisms of two-part mirror base cover (1) must not be damaged.

Fig 1: Removing Two-Part Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Slide camera (1) in direction of arrow out of mounting.

Disconnect plug connection (2).

Installation note:

Make sure camera (1) is firmly seated in mounting.

Fig 2: Sliding Camera Out Of Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

For replacement F01, F02, F03, F04, F10, F11, F18, F12, F13 to 07/2012:

Carry out calibration via BMW diagnosis system:

Service functions:

Driver assistance systems
Lane departure warning
Calibrate camera

NOTE: A new calibration is also required when the windscreen is replaced.

NOTE: Heating of camera for lane departure warning is integrated in windscreen.
If heating is defective, the windscreen must be replaced.