72 11 033 Removing and installing/replacing front left or right seat belt
Necessary preliminary tasks:
- Remove trim panels for door pillar . See 51 43 150 REMOVING AND INSTALLING OR REPLACING TRIM PANEL FOR LEFT OR RIGHT DOOR POST (BOTTOM) or 51 43 148 REMOVING AND INSTALLING OR REPLACING TRIM ON LEFT OR RIGHT DOOR PILLAR (TOP) .
- E70 only:
If necessary, remove air vent
Version with end fitting pretensioner only:
Necessary preliminary tasks:
- Remove OUTER COVER .
Release screw (1).
Tightening torque: 72 11 07AZ .
Remove lock washer.
Pull belt strap (2) out of end fitting pretensioner.
Move front seat upwards.
Release screw (1) on front seat.
Installation:
Replace screw.
Tightening torque: 72 11 02AZ .
Feed out belt anchor fitting (2).
Unfasten screws (2).
Tightening torque: 72 11 04AZ .
Remove seat belt guide loop.
Release screws (1).
Installation:
Replace screws (1).
Remove belt deflector.
Tightening torque: 72 11 5AZ .
Release screw (1).
Installation:
Replace screw.
Tightening torque: 72 11 01AZ .
Unlock inertia reel unit (2) and remove from B-pillar.
Installation:
Inertia reel unit is coded against incorrect installation (3).