65 50 160 Removing and installing/replacing trim for rear cabin monitor display at front and rear

Special tools required:

IMPORTANT: Trims may only be replaced in pairs so as to avoid differences in color.

Unclip trims (1) on both sides with special tool 00 9 340.

Installation:

Make sure trims (1) are securely seated in rear cabin monitor trim at front.

Fig 1: Identifying Rear Cabin Monitor Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Rear Cabin Monitor Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trim for display at rear (1) with special tool 00 9 340 and remove.

Fig 3: Identifying Trim For Display (Rear)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully remove trim for display at front (2) and disconnect plug connection (3).

Installation:

Make sure ribbon cable is securely seated.

Fig 4: Identifying Trim For Display (Front)

Courtesy of BMW OF NORTH AMERICA, INC.