00 00 ... Tyres: checking inflation pressure, correcting if necessary (incl. spare wheel), checking external condition, tread depth, pattern

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Checking tyre inflation pressure:
- Check tyre inflation pressure in accordance with information plate on B-pillar
- The inflation pressure in the spare wheel must be 0.5 bar higher than the maximum specified value on the information plate
- Initialize Run Flat Indicator
Checking tyre condition:
- Check tread depth of all tyres with tyre tread gauge
- Check tyre tread surfaces and side walls for incisions and foreign particles such as nails or screws
- Check tyre tread pattern for localized flattening and wear on one side; if necessary, carry out wheel/chassis alignment after consulting with customer and issue a separate invoice for this work

NOTE:

For reasons of driving safety, only use tyres of the same type and tread pattern on a single vehicle
Inform customer of any incorrect or worn tyres