51 47 490 Removing and Installing/Replacing Front Underbody Protection (AWD)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 335xi, 2008 BMW 328xi, 2007 BMW 335xi, 2007 BMW 328xi, and 2006 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Illustration created using 330xi as an example. There may be differences in detail in the case of other vehicle models.

Remove screws (1 to 4).

Pull underbody protection (5) forward under bumper trim (6).

Installation:

Centre underbody protection (5) and tighten down screws (1 to 4).

Fig 1: Identifying Underbody Protection, Forward Under Bumper Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.