64 50... A/C performance test (R 134a)

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 335xi, 2012 BMW 328xi, and 2012 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Before A/C efficiency test, satisfy following conditions:

Connect BMW diagnosis system. Check of the fault memory (no faults in the fault memory).
Attach a thermometer with separate display device to the head restraint and route the display device wiring out of the passenger compartment outward.
Perform the test in a suitable workshop area with an ambient temperature above 18° C.
Vehicle temperature should be approximately the same as the ambient temperature in the workshop.
Engine must be at operating temperature.

Heat passenger compartment:

A/C button is not activated during the heating process
Close all windows and doors
Set air recirculation function
Select air distribution mode for footwell and defrosting
On vehicles with CID: In A/C menu (CID) in Air distribution index tab: select 100 % footwell for driver and front passenger and 100 % defrosting for driver (this applies here to driver and front passenger)
Maximum temperature setting
Maximum blower speed
Start engine

Cool down passenger compartment:

Turn on air conditioning compressor with "A/C button" at a vehicle interior temperature of 45 °C (measured at the head restraint).

On vehicles with MAX-AC button:

Activation of MAX-AC (= maximum cooling power)

On vehicles without MAX-AC button:

Set maximum cooling power by means of following steps:
- Setting minimum temperature
- Blower setting maximum
- Stratification maximum cold (4 blue bars)
- Only ventilation open
- Close remaining flaps (air outlet only from center fresh air grille, left and right)

After 5 minutes measure both ventilation temperatures with a thermometer at the same time (fresh air grille center, left and right). The measured temperature must be no more than 16° C / 61° F and the difference between right and left may not be greater than 2° C / 36° F.

If one or both temperature specifications is not reached: draw off heating and air conditioning system. Measure amount of refrigerant drawn off.

If drawn-off quantity does not correspond to specified fill quantity : supplement refrigerant and repeat test.

If fill quantity is correct, continue troubleshooting by pressure measurement.