52 26... Removing and installing/replacing ski bag with casing on rear seat (through-loading system) (coupe)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove center armrest or
filler element

Press ski bag (1) on rear side out of backrest.

Fig 1: Pressing Ski Bag On Rear Side Out Of Backrest

G04727347

Courtesy of BMW OF NORTH AMERICA, INC.

Lift off cover (1).

Release screws (2).

Installation:

Make sure cover is correctly installed.

Fig 2: Identifying Cover Screws

G04727348

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip single opening trim (1) towards top.

Installation:

Plastic clips must not be damaged.

If necessary, replace faulty trim.

Fig 3: Identifying Opening Trim And Plastic Clips

G00455063

Courtesy of BMW OF NORTH AMERICA, INC.

Remove C-module trim (1) in direction of arrow.

Fig 4: Identifying C-Module Trim And Removal Direction

G00455064

Courtesy of BMW OF NORTH AMERICA, INC.