52 14... Removing and installing or replacing trim for release handle on front left or right seat (convertible)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear panel
Disconnect BATTERY NEGATIVE LEAD .

IMPORTANT: Screw (1) must not fall between airbag module and backrest frame.
If necessary, remove AIRBAG MODULE .
No sharp-edged objects permitted in area of side airbag.

Release screw (1).

Unclip side trim cover from backrest.

Installation:

Place seat belt between seat belt guide and trim cover.

Make sure the trim cover is fitted correctly in the guide.

Fig 1: Identifying Side Trim Cover Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Replacement only:

Unclip toggle switch.

Fig 2: Locating Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.