51 71... Removing and installing/replacing radiator seal

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Scalding hazard!
Only perform work after engine has cooled down.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle.
Driving without the diagonal strut is not permitted!

Necessary preliminary tasks:

Remove front underbody protection for RWD or AWD

NOTE: Prior to removing, pay attention to the exact installation position with respect to the adjoining components.

Release screws (1).

If necessary, remove underbody protection bracket.

Release catches (2) and feed out radiator seal (3) towards rear.

Fig 1: Identifying Catches And Radiator Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) must not be damaged

Fig 2: Identifying Catches

Courtesy of BMW OF NORTH AMERICA, INC.