51 11... Installing/replacing number/license plate (without base)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to number/license plate.

Remove template (1) and secure number/license plate with screws provided.

For tightening torque refer to 51 11 3AZ in 51 11 FRONT BUMPER .

Fit protective caps.

Fig 1: Bumper, Template And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Place drilling hole template (1) on radiator grille (2) and bumper (3).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to number/license plate.

Remove template (1) and secure number/license plate with screws provided.

For tightening torque refer to 51 11 3AZ in 51 11 FRONT BUMPER .

Fit protective caps.

Fig 2: Drilling Hole Template, Radiator Grille, Removal Direction And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure number/license plate (3) with number/license plate screw (4).

For tightening torque refer to 51 11 4AZ in 51 11 FRONT BUMPER .

Fig 3: Bumper, Blind Rivet Nut, Number/License Plate Screw And Number/License Plate

Courtesy of BMW OF NORTH AMERICA, INC.