LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> X6 50i >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Rear Axle - Repair - E92/E93) >> Shock Absorber >> 3300... Information on replacing shock absorbers

3300... Information on replacing shock absorbers

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Situation 

When a shock absorber is faulty on one side (leaking, noises, limit values exceeded on the shock tester), often both shock absorbers on the axle in question are replaced.

E32, E34, E38, E39:  With the rear spring struts with self-levelling suspension, a slight oil leak usually exists at the piston rod. These spring struts are permitted to be wet with oil over a maximum of half the shock absorber length on the outer tube, i.e. they are permitted to "sweat".

Effect 

This is not necessary for technical reasons and causes the manufacturer not to recognize the unnecessarily removed shock absorbers as defective parts. Unnecessarily high costs for the customer can be avoided by replacing the shock absorber on one side only.

Procedure 

If one shock absorber is damaged, it is only necessary to replace both shock absorbers when the car has driven in excess of 80 000 km.

Exception: On all M-GmbH models, when a limit value is exceeded on one side, it is still necessary always to replace both shock absorbers on the relevant axle.

Information on replacing shock absorbers on E65/E66 models with EDC before production 03/07 

Component version (build date) before 03/07:

Component version (build date) after 03/07: