32 31 090 Removing and installing/replacing steering column
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Cars produced up to 12/2004 have a steering column with a 3-pin plug connection for electric steering column locking. Cars produced after this date have a 4-pin plug connection. Spare parts are offered for both variants.
Necessary preliminary tasks:
- Remove Lower Section Of Steering Spindle
- Remove footwell heating duct
- Remove Steering Column Trims
- Disconnect all plug connections at fixture for steering column stalk
- Disconnect plug connection on electric steering column lock
- Remove wiring harnesses from steering column
Release screws (1).
For tightening torque refer to 32 31 2AZ in 32 31 STEERING COLUMN .
Secure steering column against falling out.
Unfasten screws (2).
For tightening torque refer to 32 31 2AZ in 32 31 STEERING COLUMN .
Remove steering column towards rear.
Installation:
When inserting the steering column into the sleeve, make sure the sleeve is not pressed out of the bulkhead. Check installation position of sleeve, correct if necessary.
Replacement:
After installation:
- Carry out Steering Angle Sensor Adjustment for active front steering
- Replacement only: Turn steering wheel in both directions to full lock. The airbag warning lamp must not light up in the process.
- Check directional stability of car