Pin Assignment Of The FLA Control Unit For The Main-Beam Assistant
WARNING: This page does not describe the selected car, but rather 46 other vehicles, including the 2008 BMW M5, 2008 BMW 650i, 2007 BMW Z4, 2007 BMW M6, and 2007 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
PIN ASSIGNMENT FOR FLA CONTROL UNIT CONNECTOR X18246, 10-PIN
| Pin | Type | Description |
|---|---|---|
| 1 | E | Reverse-gear signal |
| 2 | A | FBD receiver (E64 only: FBD receiver in the inside mirror) (FBD: remote-control services) |
| 3 | E | If terminal 15 ON |
| 4 | E | Negative wire for the electrochromic door mirror, left |
| 5 | A | Signal for the electrochromic door mirror, left |
| 6 | E | Negative wire for the electrochromic door mirror, right |
| 7 | A | Signal for the electrochromic door mirror, right |
| 8 | V | Power supply, terminal 30 (only if car is fitted with an anti-theft alarm) |
| 9 | E | Actuation for the DWA LED (only if anti-theft alarm fitted) (DWA: anti-theft alarm) |
| 10 | M | Earth (terminal 31) |
| A: Output E: Input M: Earth V: Power supply For current specifications regarding pin assignments, please refer to BMW diagnosis system. |
||
PIN ASSIGNMENT FOR FLA CONTROL UNIT 3-PIN CONNECTOR
| Pin | Type | Description |
|---|---|---|
| 1 | E/A | Connection, K-CAN High |
| 2 | E/A | Connection, K-CAN Low |
| 3 | - | - |
| E/A: Input/Output | ||
The pin assignment is the same for all 3-pin connectors, irrespective of connector shape.