54 37... Removing and installing/replacing gas pressurized prop on left or right main mount

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove panel for main bearing

Make a written record of the alignment of gas pressure spring (1) before removing.

Slide retaining springs (2) to end of gas pressurized prop (1) and lever gas pressurized prop (1).

Repeat procedure at other end of gas strut (1).

Installation:

Check that retaining spring is fitted correctly and replace if necessary.

Fig 1: Sliding Retaining Springs To End Of Gas Pressurized Prop And Lever Gas Pressurized Prop

Courtesy of BMW OF NORTH AMERICA, INC.

Place special tool 54 0 210 on both ends of gas pressurized prop (1) and lightly tighten screw (2).

Remove gas pressurized prop from the ball heads.

Mark length of tensioned gas pressurized prop with felt pen on special tool 54 0 210.

The tension in the gas pressurized prop can be completely relieved by releasing screw (2).

Repeat procedure on right-hand side of car.

Installation:

Always replace gas pressurized props in pairs.

Tension gas pressurized prop up to marking and install.

Fig 2: Identifying Gas Pressurized Prop, Special Tool 54 0 210, And Screw

Courtesy of BMW OF NORTH AMERICA, INC.