54 37... Gauging rear module: Notes
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 450
- 54 0 150
- 54 0 151
- 54 0 152
- 54 0 180
IMPORTANT:
The rear module brackets are gauged and the screw connection sealed at the factory.
Gauging of the brackets is only to be carried out after a repair to the body.
It is necessary in the warranty period to consult the country-specific hotline before opening the screw connection seal.
Always install and remove rear module gauge with 2 helpers.
To prevent damaging the rear module gauge, set the gauge down only in the transportation crate or on brackets.
The rear module gauge is a highly sensitive measuring instrument which reacts even to light impact with distortion.
The rear module gauge must be checked for dimensional accuracy on a master gauge after being subjected to impact or dropped.
Gauging of the brackets is only to be carried out after a repair to the body.
It is necessary in the warranty period to consult the country-specific hotline before opening the screw connection seal.
Always install and remove rear module gauge with 2 helpers.
To prevent damaging the rear module gauge, set the gauge down only in the transportation crate or on brackets.
The rear module gauge is a highly sensitive measuring instrument which reacts even to light impact with distortion.
The rear module gauge must be checked for dimensional accuracy on a master gauge after being subjected to impact or dropped.
Necessary preliminary tasks:
- Gauge roof module bracket
Tighten down rear module bracket (1) with suitable screws to special tool 54 0 150.
Tightening torque: 2 Nm
Turn back all barrel screws on rear module bracket (1) and check for ease of movement.