Gauge, coupling fastener

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Gauge, Coupling Fastener And Rubber Stop

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Coupling fastener must not be screwed into place for adjustment work (barrel screws move freely).

Slacken screw for rubber stop (1) and pull back.

Insert special tool 54 0 130 in coupling fastener.

Screw gauge for coupling fastener 54 0 131 on left and 54 0 132 right onto basic gauge with special tool 00 9 251.

Tightening torque: 6 Nm

Fig 2: Locating Screw Gauge For Coupling Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Turn L-piece (2) under stop screw (3) of coupling fastener.

Adjust coupling fastener as follows:

Set stop screw (3) with adjusting screw (1) such that it comes up against stop (4).

Stop screw (3) of the coupling fastener is aligned flush at stop (4)
The L-piece (2) should ideally rest against the gauge

Bring barrel screws into contact with special tool 54 0 180 in conjunction with 00 9 450.

Tightening torque: 0.2 Nm (=20 cNm).

Fig 3: Identifying Adjusting Screw And Stop Screw With L-Piece

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe screwing sequence of coupling fastener:

Refer to installing the roof module .

Z-direction (coupling fastener to screwing plate, rollover protection system)
Y-direction (coupling faster to side panel)
X-direction (roof frame to partition wall)

Tightening torque: see 22AZ in 54 37 POWER CONVERTIBLE TOP .