54 37... Aligning basic gauge: Notes
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 251
- 54 0 121
- 54 0 122
- 54 0 123
See.
IMPORTANT:
Always install and remove basic gauge with 2 helpers.
To prevent damaging the basic gauge, set the gauge down only in the transportation crate or on the vehicle side wall.
The basic gauge is a highly sensitive measuring instrument which reacts even to light impacts with distortion.
The basic gauge must be checked for dimensional accuracy on a master gauge after being subjected to impact or dropped.
To prevent damaging the basic gauge, set the gauge down only in the transportation crate or on the vehicle side wall.
The basic gauge is a highly sensitive measuring instrument which reacts even to light impacts with distortion.
The basic gauge must be checked for dimensional accuracy on a master gauge after being subjected to impact or dropped.
The basic gauge stipulates the basic setting in the X-, Y- and Z- axes.
The basic gauge is absolutely essential for the following work operations:
- Gauging coupling fastener
- Gauging roof module bracket
Lift out cover (1) on left base plate.
Installation:
Cover (1) for base plate must be replaced after each removal.
IMPORTANT:
The outer left hole in the base plate is the reference point for the following jobs.