31 33 001 (Removing and installing) replacing front left or right spring strut support bearing: Replacement

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle with spacer ring:

NOTE: Spacer ring (A) is fitted in vehicles with "rough road package" version.

Unscrew nuts.

Tightening torque 31 31 1AZ .

Remove spacer ring (A) from support bearing.

Installation:

Fig 1: Identifying Spacer Ring And Centering Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Align spacer ring (A) using centering pin (1) to support bearing and place in position.

Replace self-locking nuts.

If necessary, twist/drive out centering pin (1).

NOTE: If a support bearing (2) was fitted without centering pin (1), the centering pin (1) of the new support bearing (2) must be driven or twisted out.

Fig 2: Identifying Support Bearing And Centering Pin

Courtesy of BMW OF NORTH AMERICA, INC.