00...... Raising vehicle with trolley jack

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe the following trolley-jack-related instructions:

Use only BMW-distributed/approved trolley jacks which have rubber plate contact points.
Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
Check the rubber plate on the trolley jack prior to each use, replacing if necessary.

Fig 1: Identifying Trolley Jack With Rubber Plate

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: The vehicle may be raised with a trolley jack only at the following jacking points!

Car jacking point on reinforcement strut (rear-wheel drive)
Side car jacking points
Rear differential
Risk of damage: It is not permitted to raise the vehicle at the rear differential cover!
Bolting point for rear axle tension struts

Fig 2: Identifying Car Jacking Points

Courtesy of BMW OF NORTH AMERICA, INC.

Car jacking point on front axle carrier (all-wheel drive)

Fig 3: Identifying Car Jacking Point On Front Axle Carrier
Courtesy of BMW OF NORTH AMERICA, INC.