Initial fitting
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Place drilling hole template (1) on bumper (2).
NOTE:
Hole diameter = 2.5 mm (see template).
Drill holes according to car registration number plate specifications.
Remove template (1) and secure car registration number plate with screws provided.
Tightening torque 51 11 3AZ .
Fit protective caps.
Place drilling hole template (1) on radiator grille (2) and bumper (3).
NOTE:
Hole diameter = 2.5 mm (see template).
Drill holes according to car registration number plate specifications.
Remove template (1) and secure car registration number plate with screws provided.
Tightening torque 51 11 3AZ .
Fit protective caps.