LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> X6 50i >> Repair and Diagnosis >> External Pages >> Different car >> Section 1510 (Engine Electrical System - Repair - E91) >> 1200 Troubleshooting >> 61 00... Notes on handling wiring harnesses and cables >> The following additionally applies

The following additionally applies

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Shielded lines 

Contact points in the shield can cause problems with regard to noise radiation and interference immunity.

Consequently, distinctions have to be drawn between the following types:

Coaxial line 

CVBS lines 

HSD lines 

Optical fibre cable: 

NOTE: Optical fibre cables are colored differently as follows:
IMPORTANT:
  • Optical fibre cables are permitted to show only one separation point (bridge), replace optical fibre cables if necessary
  • Smallest permissible bending radius is 25 mm
  • Avoid influence of heat = 85 °

TREATING CABLES AND OPTICAL FIBRE CABLES

FlexRay: 

It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional BUTT CONNECTORS .

NOTE:
  • The line is a twisted cable. If possible, maintain twist in line after repair.

Airbag lines: 

REPAIRING AIRBAG CABLES

Ribbon cables: 

REPAIRING RIBBON CABLES Z