33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
A wheel/chassis alignment check See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD must be carried out after the following work:
- Release of following screw/bolt connections:
- Camber arm to rear axle carrier/wheel carrier
- Trailing arm to rear axle carrier/wheel carrier
- Guide arm to rear axle carrier
- Toe arm to rear axle carrier/wheel carrier
- Control arm to rear axle carrier
- Replacement of following parts:
- Rear axle carrier
- Camber arm/rubber mount/ball joint
- Trailing arm/rubber mount
- Guide arm
- Wheel carrier/rubber mount/ball joint
- Toe arm
- Control arm