11 00 Removing and installing/replacing ignition coil cover (N54)
WARNING: This page is about a different car, the 2010 BMW X6, 2009 BMW X6, and 2008 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove microfilter housing . See MICROFILTER .
Release screws.
Tightening torque 11 12 7AZ , see CYLINDER HEAD
Remove ignition coil cover (1) towards top.
NOTE:
For purposes of improved clarity, illustration and descriptions shows wiring harness and tension strut removed.