Necessary preliminary tasks

Adjust head restraint towards top to maximum extent
Disconnect BATTERY NEGATIVE LEAD

IMPORTANT: Renewal of pyrotechnics may be carried out up to 5 times.
Triggering frequency is denoted on the sticker on the head restraint carrier.
Labels are available as spare parts.

Starting situation:

Head restraint is in the crash position after activation.

NOTE: Firing unit can only be removed in the triggered state.

The complete head restraint must be replaced in the event of a crash-active headrest fault message and non-activated igniter.

Fig 1: Removing Head Restraint

Courtesy of BMW OF NORTH AMERICA, INC.

Removing cover:

Raise cover (1) and pull rearwards.

Fig 2: Raising Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Removing pyrotechnics: Press together mounting (1) for pyrotechnics at tabs. Feed out pyrotechnics.

Fig 3: Pressing Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Put down cover towards rear.

Fig 4: Putting Down Cover Towards Rear

Courtesy of BMW OF NORTH AMERICA, INC.

Removing pyrotechnics:

Press together mounting (1) for pyrotechnics at tabs.

Feed out pyrotechnics.

Fig 5: Pressing Mounting For Pyrotechnics At Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Removing pyroactivator:

Pull pyroactivator (2) out of mount (1) for pyrotechnics.

Unlock plug connection (3) and disconnect.

IMPORTANT: Dispose of plastic element and pyroactivator.

Fig 6: Identifying Pyroactivator, Mount And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Procedure for installing pyrotechnics:

Bringing head restraint together (multifunction seat):

Pull apart spring catches and push together head restraint.

Maintain position.

Fig 7: Pulling Apart Spring Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Locking release plate:

Hold pushed-together head restraint in position and push release plate (1) upwards up to limit position.

Release plate (1) must audibly snap into place.

Fig 8: Locking Release Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 9: Checking End Position Of Release Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Checking head restraint lock:

Check end position of release plate (1).

All four springs (2) must be engaged.

Replacing pyrotechnics:

Connect connector (1) to new pyroactivator (2) and lock.

Clip pyroactivator (2) into new mount (3).

Fig 10: Identifying Connector, Pyroactivator And Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installing pyrotechnics:

Press together mounting for pyrotechnics at tabs.

Insert mounting for pyrotechnics into release plate and tilt in upward direction.

Mounting for pyrotechnics must audibly snap into place.

NOTE: Check seating of retaining lugs in mounting.

Fig 11: Installing Pyrotechnics

Courtesy of BMW OF NORTH AMERICA, INC.

Laying wiring harness:

Secure wiring harness in support section with strain relief.

Fig 12: Securing Wiring Harness In Support Section With Strain Relief

Courtesy of BMW OF NORTH AMERICA, INC.

Mounting cover:

Clip cover onto support section.

Cover must audibly snap into place.

Fig 13: Mounting Headrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.