LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> X6 50i >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> General Electrical System - Service Information >> General Electrical System >> Footwell module >> Brief description of components >> Belt feeder controllers (E92 only)

Belt feeder controllers (E92 only)

The footwell module (FRM) actuates the two belt feeder controllers for the driver's side and front-passenger side. The belt feeder controllers are connected to the footwell module via a LIN bus.

The belt feeder controllers actuate the drive of the belt feeder.

The position of the drive is reported back to the belt feeder controller by a Hall sensor in the drive.

The end position of the extended belt feeder is recorded by another Hall sensor. The end position is indicated to the belt feeder controller.

The belt feeder controller transmits both signals to the footwell module (FRM) via the LIN bus. The actuation circuit is located in the footwell module.

The belt feeder on the front-passenger side is only actuated if the front-passenger seat is occupied.

scientia non olet · About LEMON Manuals