Stripping insulation from optical fibre

Open pliers (1).

Open lever (2) in direction of arrow.

Fig 1: Identifying Pliers And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Slide optical fibre (1) into stripping device (2) until flush at point (3).

Close pliers (4) fully.

Close clamping lever (5) in direction of arrow.

Open pliers (4) by one tooth notch.

Open clamping lever (5) against direction of arrow again and remove optical fibre (1).

NOTE: A stripping replacement blade set is available under number 61 4 327.

Fig 2: Identifying Clamping Lever And Pliers

Courtesy of BMW OF NORTH AMERICA, INC.