61 31 091 Removing and installing/replacing switch for (rear) left or right seat heating

Special tools required:

NOTE:

Unclip trim with special tool 00 9 340 from center console.

Installation:

Retaining lugs of trim must not be damaged or missing.

Make sure trim is correctly engaged on center console.

Fig 1: Unclip Trim With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect left or right plug connection (1).

Press together retaining lugs (2) of left or right switch for seat heating and feed switch for seat heating in direction of arrow out of trim (3).

Installation:

Make sure switch for seat heating is correctly seated in trim (3).

Fig 2: Pressing Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.