67 61 005 Removing and installing/replacing drive with gear (front) for actuating slide/tilt sunroof
Necessary preliminary tasks:
- Remove roof switch cluster , see 61 31 043 REMOVING AND INSTALLING OR REPLACING ROOF SWITCH CLUSTER .
NOTE:
Secure drive with gear for actuating slide/tilt sunroof (3) against falling out.
Unfasten plug connection (1) and disconnect.
Release screws (2), tightening torque 54 13 1AZ , see 54 0... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .
NOTE:
Screws (2) are microencapsulated.
Remove drive with gear for actuating slide/tilt sunroof (3).
Remove drive with gear for actuating slide/tilt sunroof (3).
Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).
Installation:
Replacement:
Carry out vehicle programming/coding , see VEHICLE PROGRAMMING AND CODING .