Laying cutting wire around windscreen

Starting from pull-in point, lay wire eyelet created on the outside around the window glass
Pull excess wire into car interior
IMPORTANT: Make sure the cutting wire is located at all four corner points below the windscreen.
Check that the cutting wire is not caught on retainers or body.
Secure window glass on outside with adhesive tape against slipping.

Fig 1: Laying Wire Eyelet Created On Outside Around Window Glass
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Windows (1) with fitted seals (3) or sprayed-on surrounds:
- Moisten cutting wire (4) and seals (3) on window (1) with water
- Insert cutting wire (4) in bend (without kinking) between window (1) and body cutout (2)
Fig 2: Inserting Cutting Wire In Bend (Without Kinking) Between Window And Body Cutout
Courtesy of BMW OF NORTH AMERICA, INC.