63 31 182 Replacing LED for front inside door opener

Necessary preliminary tasks:

NOTE: Operation is shown by way of example on the E70. There may be differences in detail in the case of other vehicle models.

Remove sheathing of wiring harness (1) in area (A) and remove wiring harness holder (2).

Cut through wiring harness (1) in area (A) and remove LED for front inside door opener (3).

Installation:

Adapt length of wiring harness of new LED for front inside door opener.

Fig 1: Identifying Front Inside Door Opener And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Connect wiring harness of new LED for front inside door opener using butt connectors to wiring harness (1), see 61 13... BUTT CONNECTOR FOR REPAIRING A PLUG CONNECTION .

Wrap wiring harness (1) in insulating tape.