61 35 095 Removing and installing/replacing control unit/module for seat heating (left or right rear seat)
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
.
Necessary preliminary tasks:
- Disconnect battery negative lead
- Unclip and raise rear seat . See REAR SEAT, THROUGH-LOAD .
Feed control unit/module for seat heating (1) out of rear seat (2).
Disconnect plug connections (3) and remove control unit/module for seat heating (1).
Installation:
Lay wiring harness so that it cannot be damaged when rear seat (2) is installed.
Make sure control unit/module for seat heating (1) is correctly seated in rear seat (2).