11 23 Vibration Damper
WARNING: This page is about a different variant/trim than selected.
VIBRATION DAMPER-TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Description | Tightening Specification | ||
|---|---|---|---|---|---|
| 1AZ | Hub to crankshaft (head surface oiled) | N63 | M18x1.5 | Replace screw | |
| 1. Jointing torque | 100 Nm | ||||
| 2. Angle of rotation | 60 ° | ||||
| 3. Angle of rotation | 60 ° | ||||
| 4. Angle of rotation | 60 ° | ||||
VIBRATION DAMPER-TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Description | Tightening Specification | ||
|---|---|---|---|---|---|
| 3AZ | Belt pulley/vibration damper to hub | S38/B36 | M8 10.9 | 34 Nm | |
| N40/N42/N45/N46/S38/B38 | M8 10.9 | 34 Nm | |||
| All/others | M8 | 22 Nm | |||
| 4AZ | Belt pulley to vibration damper | S38/B35 | M8 8.8 | 22 Nm | |
| S50 | M8 8.8 | 22 Nm | |||
| 5AZ | Sprocket with hub or hub to crankshaft | M40 | M16 x 1.5 | Replace screw | 310 Nm |
| M42/M43/M43TU/M44 | M16 x 1.5 | Replace screw | 330 Nm | ||
| 6AZ | Hub to crankshaft | N40/N42/N45/N46 | M16 x 1.5 | Replace screw | 300 Nm |