11 12 Cylinder Head With Cover
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD AND CYLINDER HEAD COVER-TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Description | Tightening Specification | ||
|---|---|---|---|---|---|
| 1AZ | Cylinder head bolt | N63 | M11 x 1.5 | Replace screws. | |
| Jointing torque | 30 Nm | ||||
| 1st angle of rotation | 90 ° | ||||
| 2. Angle of rotation | 90 ° | ||||
| 2AZ | Cylinder head bolt | N63 | M8 | 23 Nm | |
| 3AZ | Cylinder head cover to cylinder head. | N63 | M6 | 10 Nm | |
| 4AZ | Metal bracket to cylinder head. | N63 | M6 x 16 | 8 Nm | |
| 5AZ | Lifting eye to cylinder head. | N63 | M8 | 20 Nm | |
| 6AZ | Ignition coil cover to cylinder head cover. | N63 | M6 x 20 | 4 Nm | |
| 7AZ | Non-return valve | N63 | M14 x 1.5 | 20 Nm | |
| 8AZ | Vent connection | N63 | M8 x 1 | Replace sealing ring. | 15 Nm |
| 9AZ | ASA screw (2 x) | N63 | M6 x 20 | Replace sealing ring. | 10 Nm |
| Oil filler neck to cylinder head cover. | |||||
CYLINDER HEAD AND CYLINDER HEAD COVER-TIGHTENING TORQUE SPECIFICATIONS
| Type | thread | Tightening Specification | ||
|---|---|---|---|---|
| 11AZ | Cylinder head cover | All | M6 | 10 Nm |
| All | M7 | 15 Nm | ||
| M21 | M8 | 15 Nm | ||
| 12AZ | Oil trap to cylinder head cover | M21 | M8 | 17 Nm |
| 13AZ | Timing case to cylinder head | All | M7 | 15 Nm |
| All | M8 | 20 Nm | ||
| 14AZ | Plug for oil channel (micro-encapsulated) | M47/M57 | M12 x 1.5 | 20 Nm |
| 15AZ | Vent plugs to cylinder head (coolant) | M67 | 2 Nm | |