11 12 Cylinder Head With Cover N63 B44
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD AND CYLINDER HEAD COVER - TECHNICAL DATA
| Cylinder head height: Original dimension | mm | 134.00 ± 0.05 |
| Machining limit | mm | 133.70 ± 0.05 |
| Valve guides are not available as replacement parts. | ||
| Inside diameter of installed valve guide | ||
| Original inlet valve | mm | 6.0+0.012 |
| Original exhaust valve | mm | 6.0+0.012 |
| Tilt clearance, maximum (wear between valve and valve guide) | mm | 0.06...0.112 |
| Bearing of camshaft | ||
| Guide bearing (width) | mm | 13.993... 14.035 |