22 32 001 Replacing rubber mount for transmission mounting (ATC 450)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

22 1 051
22 1 052
33 4 465
33 4 466
22 1 102
22 1 053

Necessary preliminary tasks:

Remove crossmember for transmission mounting. See 22 32 050 REPLACING CROSSMEMBER FOR TRANSMISSION MOUNTING .

Attach special tool 22 1 051 with screw (1) on the housing. Pull out rubber mount with special tools 22 1 052 / 33 4 465 and 33 4 466.

Fig 1: Pulling Rubber Mount Using Special Tools (22 1 052/33 4 465 And 33 4 466)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: Observe installation position of rubber mount. Arrow on rubber mount must point to arrow on housing. Coat housing bore and rubber mount with Circolight, refer to BMW Parts Service.

Fig 2: Identifying Rubber Mount Installation Position With Marking On Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool22 1 102 with bolt into recesses of rubber mount.

Fig 3: Identifying Special Tool (22 1 102)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 22 1 102 / 22 1 053 / 33 4 465 and 33 4 466.

Fig 4: Installing Rubber Mount Using Special Tools (22 1 102/22 1 053/33 4 465 And 33 4 466)

Courtesy of BMW OF NORTH AMERICA, INC.