12 14 526 Replacing pulse generator on right inlet camshaft (N63): Notes

WARNING: This page is about a different variant/trim than selected.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Remove right intake filter housing , see 13 71 030 REMOVING AND INSTALLING BOTH INTAKE FILTER HOUSINGS (N63) .

Unlock plug (1) and remove.

Release screw (2).

Tightening torque 13 62 3AZ, see 13 62 SENDERS FOR CONTROL UNIT .

Remove pulse generator (3).