13 11 Carburetor
WARNING: This page is about a different variant/trim than selected.
CARBURETOR - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Carburetor to intake manifold | M10/M20/M30 | 10 Nm | ||
| 2AZ | Carburetor to insulating flange | M10/M20/M30 | 10 Nm | ||
| 3AZ | Insulating flange to intake manifold | M10/M20/M30 | 10 Nm | ||
| 4AZ | Idling shut off valve; max. | M10/M20/M30 | 5 Nm | ||
| 5AZ | Flow valve; max. | M10/M20/M30 | 28 Nm | ||
| 6AZ | Throttle valve assembly to float housing; max. | M10/M20/M30 | 9 Nm | ||
| 8AZ | Throttle valve control to carburetor; max. | 2BE | 3 Nm | ||
| 9AZ | Warm-up regulator to engine | M10/M20/M30 | 23 Nm | ||